Home / Services / Electrical · Halifax
Post the job once. BridgeTrade books a licensed, insured electrician working in your part of HRM and confirms the time window — you don’t chase anyone.
Halifax · Dartmouth · Bedford · Lower Sackville · Cole Harbour · Eastern Passage · Fall River · Waverley · Hammonds Plains · Preston · Lawrencetown · Windsor Junction. Emergency call-outs, panel work and scheduled installs.
Your request
Breaker for the kitchen trips every time the kettle goes on — Dartmouth.
Booked
Tomorrow · 9:00 AM – 12:00 PM
One post
no calling round for quotes
HRM-wide
12+ neighbourhoods covered
$150–$10,000
typical residential range
Free to post
no account, no card
Every partner carries a valid NS licence and liability cover.
Licences and certifications are checked before a partner joins the network.
Add photos when you post so the contractor can size the job before they reply.
No account, no card, no obligation to accept a quote.
Residential electrical work in HRM spans a wide band — roughly $150 to $10,000. A diagnostic call and an outlet swap sit at the bottom; a full knob-and-tube rewire sits at the top. Permit and utility coordination adds lead time, not usually cost. Every range below is confirmed in writing before work starts.
Ranges reviewed August 2026 · ranges, not quotes · partner-confirmed before booking.
| Job | Typical range | Usual timing | What moves the price |
|---|---|---|---|
| Service call and diagnostic | $150 – $300 | 1–2 days | Access and how long the fault takes to trace |
| Outlet or switch replacement | $150 – $350 | 1–3 days | Whether the box and wiring are up to code |
| Light fixture or ceiling fan install | $175 – $500 | 1–3 days | Ceiling height and whether wiring already exists |
| Breaker replacement | $200 – $450 | 1–2 days | Panel brand and breaker availability |
| EV charger installation | $900 – $2,500 | 3–10 days | Distance from the panel and spare service capacity |
| Panel upgrade to 200A | $2,000 – $4,500 | 1–3 weeks | Utility coordination, mast and meter work |
| Aluminum wiring remediation | $1,200 – $4,000 | 1–3 weeks | Number of terminations that need pigtailing |
| Standby generator installation | $3,500 – $9,000 | 2–5 weeks | Fuel source and transfer switch type |
| Knob-and-tube replacement | $4,000 – $10,000 | 2–6 weeks | Square footage and how much wall has to open |
A photo of the problem usually removes a whole round of back-and-forth.
Three buckets. If you’re in the first one, stop reading and cut power at the main breaker — in most Halifax homes the panel is in the basement near the meter.
Main breaker off, then post it marked urgent. Smoke or fire — leave and call 911 first.
Post it with a photo of the panel label — it speeds up diagnosis a lot.
Pick "Flexible" — permit and utility scheduling needs lead time anyway.
Electrical is the one trade where waiting is genuinely risky. A warm outlet or a breaker that keeps tripping is the house telling you something, and the usual answer is a voicemail box that never fills.
We’re not a directory. We’re a local marketplace connecting you with licensed HRM electricians who actually want the work.
One request. A named electrician, a confirmed window, and the quote in writing before anyone opens a panel.
These are shortcuts into the form, not separate pages — yet.
All electricians are Red Seal certified
Serves
Halifax · Dartmouth · Bedford · Sackville · Hammonds Plains
Hours
7:30 AM - 5:30 PM
Master Electrician on every job
Serves
Bedford · Sackville · Halifax · Hammonds Plains · Fall River
Hours
7:00 AM - 6:00 PM
Burning smells, scorch marks, sparks, a breaker that trips immediately on reset, or exposed wiring after water damage. If you see smoke or fire, leave the building and call 911 before anyone else.
It can be. A breaker doing its job once is normal; a breaker tripping repeatedly means a circuit is overloaded or there is a fault. Stop using that circuit and post the job with a photo of the panel label.
Most panel upgrades, new circuits and rewiring need a permit and an inspection. Your electrician handles the paperwork — build the lead time into your plan rather than the price.
Usually $900 to $2,500 installed. The two things that move it are the run length from your panel to the parking spot and whether your service has spare capacity for the load.
Not always immediately, but many insurers in Nova Scotia will not write or renew a policy on an active knob-and-tube circuit. An assessment tells you what is live and what is already abandoned in the walls.
Aluminum branch wiring from the late 60s and 70s is usually remediated rather than fully replaced — connections are pigtailed to copper at every device. Cost scales with the number of terminations, not the size of the house.
Yes. Halifax Electrical specialises in older homes and heritage properties. Older mast, meter and service-entry work adds time, so post early if you have a renovation deadline.
Halifax, Dartmouth, Bedford, Sackville, Hammonds Plains and Fall River are all covered. Share your postal code when you post the job and we’ll confirm quickly.
Not always. We focus on getting you booked with an available licensed partner. If you want more than one option, say "multiple quotes" in your request and we’ll do our best based on availability.
Yes. Include the address, tenant availability window and whether the circuit is currently isolated. We coordinate scheduling directly so you are not relaying messages.
Licensed, insured HRM electricians. Confirmed time window. Free to use, no obligation, no account required.
Sparks, burning smell or scorch marks? Cut power at the main breaker, then post it marked urgent — urgent posts are triaged ahead of the queue.
Are you a electrical tradesperson? Free to join while we build the HRM network.
Join the networkWe use cookies to enhance your browsing experience, analyze site traffic, and personalize content. By clicking "Accept All", you consent to our use of cookies. You can manage your preferences or decline non-essential cookies.
By using our site, you agree to our Privacy Policy and Terms of Service.